Model ZPLR25 is a heavy duty, zero pressure accumulation conveyor which can provide accumulation of heavier loads with no back pressure. These units come equipped with zone control logic with easy set-up for cascade or slug release modes.
BETWEEN FRAMES: 15" - 57"
LENGTH: 72" - 960"
BEGINNING ELEVATION: 12" - 108"
ENDING ELEVATION: 12" - 108"
SPEED: 10 - 120 FPM
ROLLER CENTERS: 3", 4", 6"
ROLLERS: ZPLR25 Roller - 2.50" diameter, 11ga wall tubes. ZPLR26 Roller - 2.625" diameter, 7ga wall tubes. All rollers with 11/16" hex cold rolled steel axles, spring retained. Standard bearings are precision, grease packed bearings.
BELT: Standard belt is Trackmate PVC120 with clipper lace.
DRIVE: Standard drive is end, right hand side. Optional drives include End drive left hand side or Center drive right hand side
MOTOR: 1/2 HP through 1-1/2 HP. Energy efficient and inverter duty motors also available. Voltages include 115/1/60, 208/3/60, 230/3/60, 460/3/60 and 575/3/60 & DC Voltage.
ROLLER SURFACE: Standard roller surface is carbon steel. Optional surface for 2.5" rollers includes galvanized roller tube.
SUPPORT CENTERS: Standard supports are floor supports on 10’ centers. Optional supports on 5’ centers. Ceiling supports are also available.
FRAME FINISH: Standard finish is OSHA safety blue powder. Optional colors include green, beige, gray, orange, black and yellow.
ACCUMULATION ZONES: Zone length is a multiple of roller center.
Recommended zone length is 12" longer than longest product length. Standard zone logic is for cascading accumulation.
TREAD ROLLER BRAKE: Friction type brake is actuated automatically with zone actuation to prevent coasting of product in the accumulation zones.
AIR REQUIREMENTS: Requires 40PSI air pressure of clean, filtered air at consumption of approximately 0.05 cubic feet per sensor actuation.
FILTER REGULATOR: Supplied for main air supply at input, 3/8" NPT port.
POWER SUPPLY: Includes 24 VDC power supply located near center of conveyor and capable of supplying power for up to 50 zones.
November 20, 2018
LEWCO Gravity Conveyor for Automotive Rack Storage
Full Racks are loaded on the infeed end by fork truck. Full rack conveyors have
November 6, 2018
LEWCO - Direct Conveying of Machined Engine Blocks
A system was needed to buffer automotive engine blocks through operator workstat
October 23, 2018
LEWCO Dual Lane Gravity Conveyor for Automotive Rack Storage
A nationally known automotive manufacturer was having trouble accessing the corr
P: 419-625-4014, ext. 4003